Skip to main content
ExLibris
  • Subscribe by RSS
    • Back
    Primo
    Ex Libris Knowledge Center

    Scope Changes in views wizard are not displayed in FE

    1. Last updated
    2. Save as PDF
    • Article Type: General
    • Product: Primo

    Problem Symptoms:
    ?· ? Scope updates in views wizard are not applied in FE
    ?· Uncheck/check of the PCI adaptor / EBSCO adaptor in in views wizard is not applied

    Cause:
    ? The view's tab holds the old scope definitions

    Resolution:
    1. In views wizard, update the relevant scope page
    2. If there is only one scope - create a new dummy scope
    3. Go to the tab, click edit
    4. - If there is only one scope: add the dummy scope and remove the changed scope
    - If there are more than one, remove the changed scope
    5. save the tab
    6. click edit on the tab and return to the old scope
    Note: you can delete the dummy scope now
    7. save and deploy the view.

    Category: BO Configuration

    Subject: Views Wizard

    • Article last edited: 12/5/2013