Skip to main content
  • Subscribe by RSS
  • Ex Libris Knowledge Center

    Util G 2 and the last-z34-sequence

    • Article Type: General
    • Product: Aleph
    • Product Version: 18.01

    I was following KB Item 6562 and had some questions about z34 and util g 2

    I checked the last-z34-sequence in util G 2 for my PWD50 library.
    It is currently 17306377.

    KB item 6562 seems to say that the max value of last-z34-sequence is 9999999.
    Ours is 17,306,377 - significantly higher than 9,999,999.

    Is this a problem?

    Yes, this could cause a duplicate key condition. If you havn't done so already, I recommend you clear the statistics table using UTIL A/13. After doing so, check that the last-z34-sequence counter in UTIL G/2 has been reset. If not, you can reset it using the Utility.


    • Article last edited: 10/8/2013
    • Was this article helpful?