Skip to main content
  • Subscribe by RSS
  • Ex Libris Knowledge Center

    Overview of the SP Utility

    During the installation of the SP, the install script automatically runs the mandatory implementation scripts to update your Primo servers.
    Installation scripts, which are dependent on your Primo topology or configuration, cannot be performed by the installation script. These scripts, if any, require you to run them manually via the sp.utility command, which is located under the following directory, where <v/> is the Primo version in which Primo was first installed, <r> is the minor release, <x> is the Primo copy, and <u>  is the SP number:
    To determine if any implementation scripts require you to run them manually, review the Release Notes and run the scripts that apply to your configuration.
    Although the scripts are optional, the benefit of some updates may not be in effect until you run the scripts.
    From the main menu (see SP Utility - Main Menu) of the SP Utility, you can perform the following tasks:
    • Run implementation scripts
    • Roll back the SP
    Welcome to Service Pack utility.
    Your current Service Pack is 2.0.1.
    0. Exit Procedure
    2. Run Implementation Scripts
    9. Rollback
    Please select [0]:
    SP Utility - Main Menu